 |
 |
 |
|
Webasto KoolAir PM500 Sea Water Magnetic Drive Pump - Run Dry Capability - 115V
The Koolair PM500-115 is a completely submersible seal-less centrifugal magnetic pump drive (10lbs) generating a maximum flow of 8.5 gallons per minute with a maximum head of 19 feet at 8.2 PSI.
The pump is dry run protected to withstand thermal overloads without failure. When cooled, the pump will resume operating normally.
Materials exposed to the solution (wet end) are Reinforced Polypropylene, Buna N, Cupro Nickel, Ceramic, and Ceramic Magnet. When submerged, Epoxy, Stainless Steel, Polysulfone, and the Cord will also come in contact with the solution.
The inlet connection is a 3/4" female pipe thread and the outlet is 1/2" male pipe thread.
Includes fully integrated, heavy duty marine base, as well as the original base
The motor is a 1 Phase 115V, .05 Horsepower motor, running on either 50 or 60 HZ
Maximum internal pressure is 25 PSI and the maximum liquid temperature is 130° Fahrenheit or 54° Celsius.
- Max Flow: 8.5 GPM 31 LPM
- Max Head: 19 FT 4.3 M
- Power: .05 HP .037 KW
- Electrical: 115V 50/60 HZ
- Submersible: Yes
- Inlet: 3/4" FPT
- Outlet: 1/2" MPT
- Wet End: Polypropylene (Front and Rear Housing, Impeller), Cupro Nickel (Cooling Tube), Buna N (O-Ring, Cooling Tube Seal), Ceramic (Shaft, Thrust Washer), Ceramic Magnet
- Uses: Submersible or Open Air
- When submerged, the following is also in contact with the solution: Epoxy, Stainless Steel, Polysulfone, Cord
Koolair PM500-115 Magnetic Drive Pump 3/4"FPT Inlet 1/2"MPT Outlet, 8.5 GPM @ 19 Feet of Head (31 LPM @4.3M). Includes original base and the fully integrated marine base. Completely submersible, with run dry protection (10 lbs.), .05 HP (.037 KW) 115 volt 50/60HZ.
|
|
|
 |
|
 |
|
