GLOSSARY OF TERMS

AMPS Workload - determined as up to the maximum amps.

Anchor Rode - the line that secures the anchor to the vessel, consisting of either rope, chain, or a combination of rope and chain.

Automatic Free Fall - windlass releases automatic clutch by means of a remote switch for rapid deployment. No user interaction.

Bridle - chain stopper/compressor, devils claw. Located between the winch and bow roller. Secures chain and takes load off the winch/windlass.

Capstan - drum, rope drum. The capstan is used for hauling rope.

Displacement - the amount of water displaced by a floating vessel, usually measured in tonnes.

Fixed Drive - direct couple from transmission to gypsy/capstan.

Free Fall - release of clutch manually releases the chain to freefall.

Gypsy, Chain Gypsy, Wildcat, Chain Wheel - a special wheel with pockets to suit chain and or rope for hauling up the anchor and anchor rode.

Hauling - weighing, lifting. The operation of lifting anchor, rope or chain.

Howser - chain pipe that anchor rode feeds through into locker.

Horizontal Windlass/Winch - Drive shaft, capstan and gypsy are located horizontally to the deck.

Inline Drive - powerful and efficient integrated gearbox and motor.

Manual Operation System (MOS) - handle fits directly into gypsy by removing the capstan or clutch top.

Manual Override System (MORS) - handle fits into windlass top and overrides the transmission and ratchet drive system. Power backup can be used.

Maximum Load - the maximum operating load that could be applied to the windlass, but the load the winch would normally be subjected to is substantially less.

Maximum Line Speed - the maximum speed at which the anchor rode could be retrieved.

Ratchet Drive - indirect couple from transmission to gypsy/capstan via a ratchet cone. This allows for normal powered operation and manual operation where some power is available.

RCMS - Rope Chain Management System - refer to Accessories for further information.

Vertical Windlass / Winch - drive shaft, capstan and gypsy are located vertically to the deck.

Workload - typical lift. Usually up to 25 percent of the Maximum Load.

ABBREVIATIONS